DAGWOOD'S VAC SERVICES

Dagwood’s Vac Services provides fast, friendly, knowledgeable vac truck services. 

Including Holding Tank, Septic Tank, Catch Basin, and Sump Pump Pump Out. 

Big Enough to Serve You, Small Enough to Know You!

Big Enough to Serve You, 

Small Enough to Know You!

Vacuum Truck Services Edmonton AB
Vacuum Truck Services Edmonton AB

Edmonton Sewer & Septic Pumps


What you need to know about septic pumps for your sewer system.

What Is A Septic Tank Pump? How Does It Work? 


What Is A Septic Tank Pump?

How Does It Work? 


A septic tank pump is an essential component of a septic system. It can also be referred to as a sewer pump. Septic pumps are responsible for moving wastewater from the septic tank to the drain field or a secondary treatment system. They're typically installed in the septic tank itself, where they sit at the bottom and pump out the effluent when it reaches a certain level.


The primary function of a septic tank pump is to prevent the septic tank from overflowing and causing a back-up in the home's plumbing system. As liquid waste and septic waste enters the septic tank, it settles into layers, with the solids sinking to the bottom and the liquid effluent rising to the top. Over time, the solids accumulate and must be pumped out by a septic tank pumping company. However, the liquid effluent must also be removed from the tank and transported to the drain field or secondary treatment system.


This is where the sewer or septic tank pump comes in.


When the effluent in the tank reaches a certain level, a float switch or pressure sensor triggers the septic tank pump to turn “on” float. The pump then uses a motor to pull the liquid waste through a pipe and out of the tank. The semi-treated wastewater is then transported to the drain field or secondary treatment system, where it can be further treated and dispersed into the soil.

2 Reasons For Sewer Pump

Replacement Services


2 Reasons For Sewer Pump Services


Sewer pumps are designed to pump wastewater from a lower point to a higher point in a sewer system. Over time, these pumps can fail, and they may need to be replaced. We recommend calling an insured septic pump replacement company to see if your septic or sewer pump in West Edmonton, Acheson, Stony Plain, and Spruce Grove, Alberta, areas need to be replaced.


Here are two common reasons for sewer or septic pump replacement:


#1 - The motor is burnt out


Over time, the motor may become worn or damaged, causing it to overheat and burn out. This can occur due to a lack of proper maintenance, excessive use, or simply old age.


#2 - The float isn't working


The float is responsible for turning the pump on and off based on the level of wastewater in the basin. If the float is not working correctly, the pump may not turn on or may run continuously, which can cause damage to the pump and the plumbing system. In these cases, the float may need to be adjusted or replaced, or the entire pump may need to be replaced.

Sewer pumps are designed to pump wastewater from a lower point to a higher point in a sewer system. Over time, these pumps can fail, and they may need to be replaced. Give Dagwood Vac Services a call to see if your septic or sewer pump in West Edmonton, Acheson, Stony Plain, and Spruce Grove, Alberta, areas need to be replaced.


Here are two common reasons for sewer or septic pump replacement:


#1 - The motor is burnt out


Over time, the motor may become worn or damaged, causing it to overheat and burn out. This can occur due to a lack of proper maintenance, excessive use, or simply old age.


#2 - The float isn't working


The float is responsible for turning the pump on and off based on the level of wastewater in the basin. If the float is not working correctly, the pump may not turn on or may run continuously, which can cause damage to the pump and the plumbing system. In these cases, the float may need to be adjusted or replaced, or the entire pump may need to be replaced.

We want to hear from you!

What Happens When Your

Septic Tank Pump Stops Working?


You may think septic tank emptying services are a hassle, but it could be worse. If the septic pump fails to remove wastewater from the tank, the tank can become overloaded, leading to a back-up of wastewater and sewage into the plumbing system. This can cause toilets, sinks, and other fixtures to back up and overflow, creating a messy and potentially hazardous situation. In addition, an overloaded septic tank can cause sewage to seep into the ground, contaminating the soil and groundwater. Failing to address a malfunctioning sewer pump can lead to costly repairs, health hazards, and environmental damage. That is why we recommend proactively calling an insured septic pump replacement company to get it inspected, replaced and performing optimally.

Our Service Area

Edmonton

Stony Plain

Spruce Grove

Acheson

Winterburn

Carvel

Parkland County

Devon

Spring Lake

Jackfish Lake

Genesse

Keephills

Edmonton

Acheson

Parkland County

Carvel

Stony Plain

Winterburn

Devon

Genesee

Spruce Grove

Spring Lake

Jackfish Lake

Keephills




Share by: